Table of Contents
Advertisement
I Setting the RS-232C Interface Conditions
This plotter can retain six different combinations of RS-232C interface conditions in its internal memory, three of
which can be revised to best suit your application.
Your plotter comes with the conditions of each RS-232C interface mode set to the following settings.
RS mode
Interface conditions
RS-1
9600 bps, even parity, 7 bits, Xon/Xoff handshaking
RS-2
9600 bps, no parity, 8 bits, hardwire handshaking
RS-3
9600 bps, odd parity, 8 bits, Xon/Xoff handshaking
USER-1
9600 bps, even parity, 8 bits, hardwire handshaking
USER-2
9600 bps, odd parity, 8 bits, Xon/Xoff handshaking
AUTO
9600 bps, odd parity, 7 bits, hardwire handshaking
NOTE
You can change the settings of the USER-1, USER-2, and AUTO modes, but those of RS-1 through RS-3
cannot be altered.
When you receive your plotter, its functions are set as follows (the RS mode is set to USER-1).
Baud rate
Handshake mode
Data length
Parity
Command mode
Paper size
Programmable resolution
Pen/Vector sorting
Pen speed mode
Pen-up speed mode
Selecting the RS Mode
To automatically connect to the computer (AUTO mode), to revise the interface conditions of AUTO mode, or to
manually select one of the five other manual modes (USER-1, USER-2, RS-1, RS-2, RS-3), follow the steps
below.
(1) Press the
MO DE
(2) Press the
or
(3) Press the
E N T E R
(4) The prompt below appears.
If you wish to manually select one of the five manual RS modes and/or change the settings of USER-1,
USER-2, or AUTO mode, press the
To connect to the computer in AUTO mode, press the
Mode is Selected" on page 2-12.
: 9600 bps
: Hardwire
: 8 bits
: Even
: FP-GL
: ISO A3
: 0.1 mm (100 µm)
: On
: Manual (the pen speed set at the plotter's panel overrides any command
input specifying the pen speed)
: NormalSp
key and then press the
key to display the message below.
key to enable selection of an RS-232C interface mode.
key.
Setting?
Man Auto
or
key to display the message below.
Setup
DipSW.
Setup
RS232C
key and then skip to Step (5) of "When AUTO
2-10
Hide quick links:
Advertisement
Table of Contents
