GRAPHTEC MP303-04 User Manual page 42

(3) When the desired pen type is displayed, press the
(4) Finally, the currently selected pen type is displayed (in this case, water-based fiber-tip pens).
(5) To return to Ready mode, press the
I Setting the Pen Speed/Force for Individual Pen Nos.
This method lets you set the pen speed in a range of 1 to 70 cm/s in 1 cm/s increments for each pen number.
The pen force can be switched between H (HIGH) and L (LOW).
I Procedure
(1) With the plotter in Ready mode (the coordinates of the current pen position are displayed), press the
key. The currently selected pen type is displayed.
M OD E
(2) To set the pen speed and pen force for individual pen numbers, press the
below appears.
(3) To select the pen number, press the
Select "ALL" to set the same pen speed and pen force for all pen numbers.
(4) To select the pen speed, press the
Speed
OK!
P e n T y p e
W . F i b e r
key.
M O D E
X=
Y=
Pen Type
W.Fiber
Pen Type
Manual
or key to cycle through the available choices as shown below.
ALL 1 2
8 7 6
No.=ALL
Sp70,FoH
or key to cycle through the available range of 1 to 70 cm/s.
1 2 3
No.=ALL
Sp70,FoH
3-5
key. The message below appears briefly.
E N T E R
3 4
5
6 8 6 9 7 0
or key until the display