GRAPHTEC MP303-04 User Manual page 45

I Direct numeric input
(4) Press the
M O D E
Use the or
To switch between + and –, press the
desired numeral is displayed.
(5) When the desired position of P1 is displayed, press the
To cancel the setting, press the
When the
ENTER
set.
To set the P2 position, repeat Steps (4) and (5).
(6) When both the P1 and P2 points are set to the desired positions, press the
mode.
NOTE
If the Sort mode is set to ON, the P1 or P2 point cannot be set from the control panel. Though the pen
carriage moves to the currently selected P1 or P2 point in Step (3), you will not be able to proceed to Steps
(4) through (6).
Scaling
key to permit the P1 position to be selected by numeric input of the coordinates.
key to move to the column you wish to change (the selected column blinks).
X=+00000
Y=+00000
X=+00300
Y=+00000
C AN C EL
key is pressed, the message below briefly appears and then the P2 position can be
SetPoint
Plotting a mirror-image
or key. To set a numeral, press the
ENTER
key instead of the
E N T E R
P1
OK!
P2
3-8
or
key.
key.
key to return to Ready
MOD E
key until the