GRAPHTEC MP303-04 User Manual page 36

When AUTO Mode is Selected
(5) Pressing the key displays the prompt below
Send plot data to the plotter from the computer while this prompt is displayed.
(If the key is pressed (in local mode), it is automatically reset.)
PAUSE
(6) If the AUTO mode interface conditions retained in the plotter's internal memory have not been changed,
the plotter displays the current settings followed by the "Online" message to indicate that the plotter can
begin receiving and plotting data from the computer.
(7) If the AUTO mode interface conditions retained in the plotter's internal memory have been changed, the
plotter reads and then briefly displays the new settings, and then displays the "Online" message when it
can begin receiving and plotting data from the computer
(8) If the prompt below appears, stop sending data to the plotter and then press the
(9) When the plotter recognizes the new settings, the plotter enters Ready mode and the message below
appears. When data is resent from the computer, the plotter enters Online mode and can begin receiving
and plotting data from the computer.
If the "Ready" Message doesn't Appear after Step (8)
(9) If the plotter doesn't recognize the new settings, the message below appears.
(10) Press the
ENTER
Send data to the plotter from the computer while this prompt is displayed.
Setting?
Man Auto
< 96-E8>
< 96-E8>
PressEnt
X=
Y=
PressEnt
key to display the prompt below and enable the plotter to read the new settings again.
Send
Data !
OK !
Online
OK !
Retry !
Error!
Send
Data !
2-12
key.
E N T E R