GRAPHTEC MP303-04 User Manual page 4

Safety Precautions (Continued)
Do not use or store the plotter in a location ex-
posed to direct sunlight or the direct draft of an air
conditioner or heater.
• Such location may impair the performance of the plot-
ter.
Prohibited
Do not place any receptacle containing water or
other fluid on top of the plotter.
• Fluid falling inside the plotter may cause electrical
shock or a fire hazard due to current leakage.
Avoid water Beware of electrical shock
When disconnecting the power cable or an inter-
face cable, do not pull on the cable.
• Such action will damage the cable, resulting in a fire
hazard or electrical shock. Be sure to hold the power
cable's plug or the interface cable's connector.
Prohibited
Do not attempt to lubricate the plotter's mecha-
nisms.
• Such action may cause it to break down.
Prohibited
CAUTION
Do not use or store the plotter in an excessively
dusty or humid location.
• Such location may impair the performance of the plot-
ter.
Prohibited
Do not install, use, or store the plotter in a loca-
tion subject to excessive mechanical vibration or
electrical noise.
• Such location may impair the performance of the plot-
ter.
Prohibited
If water or foreign matter enters inside the plotter,
do not continue using it. Turn off its power and un-
plug its power cable from the electrical socket.
• Use of the plotter in such status may result in electri-
cal shock or a fire hazard due to current leakage.
• Contact your sales representative or nearest vendor
to request repair.
Unplug the power
cable from the socket
Do not clean the plotter using a volatile solvent
(such as thinner or benzene).
• Such action may impair its performance.
Prohibited
iii