Table of Contents
Advertisement
2.1 Selecting the Command Mode
Just as there are programming languages used for controlling the operation of a computer, there are also
programming languages that are specifically designed for use with plotters.
This plotter has three resident command sets: two sets of Graphtec commands (MP-GL and FP-GL) plus HP-
GL™ emulation commands that enable your plotter to emulate a Hewlett-Packard 7475A plotter. Set the com-
mand mode to match the commands used in your application program.
(1) Press the MOD E key and then press the
(2) Press the ENTER key to display the command selection menu that shows the currently selected com-
mand mode (in this example, FP-GL).
(3) Each time the
(the bits which affect command mode selection blink).
(4) When the desired mode is displayed, press the ENTER key. The prompt below appears.
(5) If the setting is correct, press the E N T E R key. Pressing the key resets the plotter to allow your new setting
to take effect. To cancel the setting and return to Step (1), press the C AN C EL key.
or
key is pressed, the command mode setting changes in the sequence shown below
Ready
Ready
or
key to display the message below.
Setup
DipSW.
F P - G L
MP-GL
H P - G L
- -- - - -
Reset?
ENTorCAN
X=
or
Y=
2-2
Hide quick links:
Advertisement
Table of Contents
