GRAPHTEC MP303-04 User Manual page 35

Manually Selecting or Changing the Interface Conditions
(5) Pressing the key displays the currently selected interface conditions as shown below.
(6) Press the (or
selected interface conditions in the six RS modes.
You can change the settings of USER-1, USER-2, or AUTO while the current settings of the respective
mode are being displayed.
Press the or
NOTE
If you wish to cancel your revisions, press the
After selecting the target condition, press the
User-1
192-E8-H
96-O7-X
48 N
24
12
(7) Check that the displayed interface conditions of the selected RS mode are correct, then press the
key. The message below is briefly displayed.
(8) The message below reappears with the characters in the lower row blinking.
Press the
MOD E
NOTE
If you wish to connect to the computer in AUTO mode after changing the AUTO mode's interface conditions,
return to Steps (1) through (4) on the previous page and then skip to Step (5) below.
) key to consecutively cycle the display forward (or backward) through the currently
key to select the interface condition you wish to change (the selected condition blinks).
User-1
96-E8-H
RS-3
96-O8-X
key to exit the Setup mode.
User-1
96-E8-H
User-2
96-O8-X
RS-2
96-N8-H
key before proceeding to Step (7).
C A N C EL
or key to change its setting as shown below.
192 19200 bps baud rate
96 9600 bps baud rate
48 4800 bps baud rate
24 2400 bps baud rate
12 1200 bps baud rate
E Even parity
O Odd parity
N No parity check
8 8-bit data length
7 7-bit data length
H Hardwire handshaking
X Xon/Xoff handshaking
E ENQ/ACK handshaking (HP-GL™ mode only)
Setting
OK !
Setup
RS232C
2-11
Auto
96-O7-H
RS-1
96-E7-X
ENTER