Controls and Indicators
This chapter identifies and describes the functions of the L180 Tape Library
operator panel and lists tasks the operator can perform through the panel.
Figure 2-1 on page 2-2
Operator Panel
The operator panel is recessed into the library's rack door and contains buttons,
indicators, and a graphic display.
The operator panel allows you to:
• Monitor current information about the library's readiness
• Help resolve library problems if an error occurs
• Set library, network, and drive configurations
• Rotate the CAP
• Replace drive cleaning cartridges and set cleaning cartridge warning count
• Run library and drive tests
• Reset (starts an initial program load [IPL] on the library).
Indicators
Three indicators on the operator panel provide basic status information:
• Library Active
• Service Required (note: contact your service provider)
• Open
Buttons
Five buttons appear on the operator panel:
•
CAP
•
MENU
•
SELECT
• Up arrow
• Down arrow
The up arrow, down arrow,
that are under operator control. As you scroll down or up a list of selections,
the cursor underscores values you can change.
95895
shows an example of the operator panel.
and
MENU,
SELECT
Ninth Edition
buttons control only the values
2
2-1