BRKT
7. Install the tilt cylinder end screw C, and
then tighten it to the specified torque.
Cylinder-end screw wrench:
90890-06544
Tilt cylinder end screw C:
90 N·m (9.0 kgf·m, 65 ft·lb)
8. Fully extend the tilt rod, and then add suf-
ficient fluid of the recommended type to
the correct level.
9. Install the reservoir cap D.
Bleeding the power trim and tilt
(not installed)
1. Close the manual valve 1 by turning it
clockwise.
7-41
Bracket unit
2. Place the power trim and tilt in an upright
position.
3. Check the fluid level in the reservoir.
NOTE:
The fluid level should be at the brim of the
filler hole.
4. If necessary, add sufficient fluid of the
recommended type to the correct level.
5. Install the reservoir cap.
6. Connect the PTT motor leads 2 to the
battery terminals.
62Y5A11