Yamaha FT50C Service Manual page 208

BRKT
2. Install the O-ring 3 to the end screw.
3. Install the tilt ram 4 into the end screw.
4. Install the backup ring 5 and O-rings 6
and 7 into the trim cylinder end screw
8.
5. Install the trim cylinder end screw onto
the tilt ram.
6. Install O-rings 9 and 0 onto the trim pis-
ton A, and then install the trim piston to
the trim cylinder B.
7. Install the backup ring C and O-ring D
into the tilt piston E.
7-39
Bracket unit
8. Install balls F and G, absorber valve pin
H, spring I, pins J and K, and washer
L into the tilt piston.
9. Hold the tilt ram end in a vise using alu-
minum plates on both sides.
10. Install the tilt piston to the tilt ram by
installing the bolt, then tightening it to the
specified torque.
Tilt piston:
61 N·m (6.1 kgf·m, 44 ft·lb)
11. Install the trim cylinder onto the tilt ram.
12. Hold the trim cylinder M in a vise using
aluminum plates a on both sides.
NOTE:
Place the trim cylinder in the vise horizon-
tally.
13. Install the trim cylinder end screw N, and
then tighten it to the specified torque.
62Y5A11