Removing And Installing The Oil Filter; Disassembling The Cylinder Body - Yamaha FT50C Service Manual

POWR

Removing and installing the oil filter

1. Place a rag under the oil filter, and then
remove the filter.
Oil filter wrench: 90890-01426
NOTE:
Be sure to clean up any oil spills.
2. Apply a thin coat of the new engine oil to
the O-ring of the new oil filter.
3. Install the oil filter, and then tighten it to
the specified torque.
E
5-37
Power unit
S62Y5690
S62Y5700
Oil filter wrench: 90890-01426
Oil filter: 18 N·m (1.8 kgf·m, 13 ft·lb)

Disassembling the cylinder body

1. Remove the exhaust cover bolts in the
sequence shown.
2. Remove the crankcase bolts in the
sequence shown.
S62Y5710
62Y5A11