Removing The Propeller Shaft Housing Assembly; Disassembling The Propeller Shaft Housing - Yamaha FT50C Service Manual

LOWR
Removing the propeller shaft
housing assembly
1. Straighten the claw washer tabs a, and
then remove the ring nut and claw
washer.
Ring nut wrench 3 1: 90890-06511
Ring nut wrench extension 2:
90890-06513
2. Pull out the propeller shaft housing
assembly.
Bearing housing puller claw L 3:
90890-06502
Stopper guide plate 4: 90890-06501
Center bolt 5: 90890-06504
Disassembling the propeller shaft
housing
1. Remove the reverse gear and thrust
washer.
6-13
Lower unit
Bearing separator 1: 90890-06534
Stopper guide plate 2: 90890-06501
Stopper guide stand 3:
90890-06538
Bearing puller 4: 90890-06535
Bearing puller claw 1 5:
90890-06536
NOTE:
Install the bearing separator 1 between the
reverse gear and thrust washer completely,
then the other special service tools.
2. Remove the ball bearing.
Stopper guide plate 6: 90890-06501
Stopper guide stand 7:
90890-06538
Bearing puller 8: 90890-06535
Bearing puller claw 1 9:
90890-06536
3. Remove the oil seals and needle bear-
ing.
62Y5A11