19.6 PTZ / RS485 Device
This menu will allow you to configure the attached PTZ or other device connected
to the RS485 ports on the rear of the DVR.
【Channel】Choose the dome camera input channel.
【Protocol】Choose the corresponding dome protocol. (PELCOD as an
example)
【Address】Set the corresponding dome address. Default: 1.(Note:
The address must be consistent with the dome address.)
【Baudrate】Choose the corresponding dome baud rate length. You can
control the PTZ and vidicon. Default: 115200.
【Data bits】Includes 5-8 options. Default: 8.
【Stop bits】Includes 2 options. Default: 1.
【Parity】Includes odd check, even check, sign check, blank check.
Default: void.
【Protocol】choose related protocol of brand model
【Address】set with corresponding address, default is 1
【Baud rate】choose the baud rate that the related device uses, default is
115200
【Data bits】including 5-8 options,default is 8;
© Copyright QVIS® All documentation rights reserved.
Pic 4.37 PTZ configure
55