Qvis Pioneer-4 User Manual page 28

【Period】Trigger the motion detect signal in the set time section. You can set
according to week or you can set uniformly. Each day is divided into four time
sections.

【Interval】Only one alarm signal is turned on even there are several
motion detect signals in the set interval.

【Alarm output】Start the external equipment of corresponding linkage
alarm when the motion detect alarm is turned on.

【Delay】Delay a few moments and stop when the alarm state is turned
off. The range is 10~300 seconds.

【Record channel】Choose the recording channel (multiple option
supportive). Trigger the video signal when the alarm is turned on.
Note: Set in the [recording setup] and perform the linkage recording. Start detecting
video files in the corresponding time section.

【Tour】■ means that the selective channel is single window alternate
patrol preview. The interval is set in the [Main Menu]>[System] > [Tour].

【PTZ Activation】Set the PTZ activation when the alarm is turned on.
Note：to link PTZ, you need to go [Shortcut menu]->[PTZ control] to set preset
point, cruise between points & interval time, etc.
© Copyright QVIS® All documentation rights reserved.
Set the time section
27