Qvis Pioneer-4 User Manual page 86

23. Cannot see the preview picture the digital channel
Possible reasons:
A. Did not add device
B. The device of related channel was not enabled.
C. The device of related channel was not selected.
D. The selected device did not connect to video sources
The channel title of selected remote device does not exist.
E.
Stream for remote channel was set by extra stream.
F.
G. User name & password not matched
H. Directly inputted the IP address or port No. incorrectly when adding
device.
The resolution of added device is too large to display by the monitor.
I.
24. Click "search" why not search out any of the device.
Possible reasons:
A. There is no other device existing within the Local area network
B. The subnet mask setting is incorrectly in the Network settings.
25. The snapshot at alarm function was enable, why not catch picture
Possible reasons:
A. HDD manage without partition for snapshot.
B. Partition for snapshot is 0
C. The snapshot function is not enabled on record-> storage of related
channel.
26. The time shows on digital channel is not the same as local side:
A. Enable the time synchronise function of the digital channel.
27. Cannot see preview picture of analog channel
Possible reasons:
A. The camera did not connect to video interface
© Copyright QVIS® All documentation rights reserved.
85