2C9
1-3-4 Installing the DP (option)
<Procedure>
1. Remove the original holder and remove the two
screws from the rear top cover.
2. Pass the two pins through the screw holes of the rear
top cover and attach them to the lower frame.
3. Place the DP on the copier by fitting the pins into the
holes at the hinge sections of the DP and sliding
them toward the front side.
4. Secure the DP with the two chrome TP screws M4 x
10 and the two screws that have been removed in
step 1.
1-3-8
Pin
Screw
Figure 1-3-10
DP
Pin
Hole
Figure 1-3-11
Chrome
Chrome
TP screw
TP screw
M4 x 10
M4 x 10
Screw
DP
Figure 1-3-12
Pin
Screw
Pin
Hole
Screw