Adjusting The Amount Of Slack In The Paper - Kyocera KM-1620 Service Manual

2C9

(7-5) Adjusting the amount of slack in the paper

Make the following adjustment if the leading edge of the copy image is missing or varies randomly, or if the copy paper is
Z-folded.
Procedure
Enter maintenance mode.
Enter "051" using the numeric keys.
Press the start key.
Select the item to be adjusted using
copy exposure adjustment keys.
Press the interrupt key.
Press the start key
to make a test copy.
edge of the image missing
or varying randomly (copy
paper Z-folded (copy
Press the stop/clear key to
exit maintenance mode.
1-6-16
Start
Is the leading
example 1)?
No
Is the copy
example 2)?
No
End
Original
G Copy exposure adjustment keys
Exp. 1 (lit): Drawer
Exp. 2 (lit): Bypass tray
Exp. 3 (lit): First paper feeder
Exp. 4 (lit): Second paper feeder
Exp. 5 (lit): Third paper feeder
Exp. 1 (flashing): duplex copying (second face)
Press the start key.
The new setting is stored.
Yes
Increase the value using the zoom (+) key.
Yes
Decrease the value using the zoom (–) key.
Setting range (Initial setting)
Drawer: –50 – +50 (20)
Bypass tray: –50 – +50 (0)
First paper feeder: –50 – +127 (70)
Second paper feeder: –50 – +127 (80)
Third paper feeder: –50 – +127 (80)
Duplex copying: –50 – +50 (0)
Changing the value by 1 changes
the amount of slack by 0.32 mm.
The greater the value,
the larger the amount of slack;
the smaller the value, the smaller
the amount of slack.
Copy Copy
example 1 example 2
Figure 1-6-28