Bottom side removals
Power supply removal
1
Remove the left cover. See
2
Remove the rear door and cover. See
318.
3
Disconnect the fuser cable from the power supply, and disconnect the transfer roll cable from the left side of the
printer.
4
Position the printer so that it sits on its right side.
5
Remove the five metal screws (A) and the plastic screw (B) securing the power supply.
6
Remove the power supply, and then disconnect the cable from the power supply.
Power supply shield removal
1
Remove the left cover. See
2
Remove the rear door and cover. See
318.
3
Remove the power supply. See
4
Position the printer so that it sits on its right side.
"Left cover removal" on page
"Rear exit door removal" on page 317
"Left cover removal" on page
"Rear exit door removal" on page 317
"Power supply removal" on page
Repair information
298
239.
and
"Rear cover removal" on page
239.
and
"Rear cover removal" on page
298.
7016