UI Automation
Once enabled, this setting creates an ENABLE_UI_AUTOMATION file in the /var/fs/shared/ directory. As long as this
file exists, the printer permits external developers to test the stability of their applications against the printer to make
sure that their applications have an appropriate level of stability. Disabling this setting deletes the file and prohibits
automated testing.
To change the setting:
1
From the Configuration menu, navigate to UI Automation.
2
Select from the available options to change the setting.
•
Enable
•
Disable (default)
3
Depending on the printer model, press OK or touch
menu without saving any changes.
LES Applications
Note: This setting is for touch-screen models only.
This menu setting is used to enable or disable Lexmark Embedded Solutions (LES) applications.
To change the settings, perform the following steps:
1
From the Configuration menu, navigate to LES applications.
2
Press the left or right arrow to navigate, then select Enable or Disable.
3
Touch Submit.
Press Back to return to the Configuration menu.
Key Repeat Initial Delay
Note: This setting is available only on the MS610de model.
This setting determines the length of delay before a repeating key starts repeating. The range is 0.25–5 seconds, with
increments of 0.25. The default setting is one second.
To adjust this setting:
1
From the Configuration menu, navigate to Key Repeat Initial Delay.
2
Touch the arrow keys to adjust the setting.
3
Touch
to save the setting, or press X to return to the Configuration menu without saving any changes.
to save the setting, or press X to return to the Configuration
Service menus
211
7016