Lexmark MX610 Service Manual page 93

Stapler carriage jam service check
Action
Step 1
Open the stapler service cover. Reseat the sensor (stapler throat) cable.
Then reseat also the other end of the cable on the controller card, and
then POR the machine.
Does the error remain?
Step 2
Open the stapler right cover. Reseat the stapler carriage assembly cables.
Then reseat also the other end of the cables on the controller card, and
then POR the machine.
Does the error remain?
Step 3
Enter Diagnostic mode and navigate to:
FINISHER TESTS > Staple Test
Does the error remain?
Step 4
Check the stapler interface cable. If damaged, then replace the cable. See
"Stapler interface cable removal" on page
Reseat the interface cable on the controller card, and then POR the
machine.
Does the error remain?
Step 5
Reseat all connectors on the controller card, and then POR the machine.
Does the error remain?
374.
Diagnostic information
93
Yes No
Replace the stapler The problem is solved.
accumulator assembly.
See "Stapler
accumulator assembly
removal" on page
393.
POR the machine. If the
error persists, then go
to step 2.
Go to step 3. The problem is solved.
Replace the stapler The problem is solved.
carriage assembly. See
"Stapler carriage
assembly removal" on
page 358.
POR the machine. If the
error persists, then go
to step 4.
Go to step 5. The problem is solved.
Replace the stapler The problem is solved.
controller card. See
"Stapler controller
card removal" on
page 368.
7016