Stapler Cooling Fan Removal; Stapler Power Supply Unit Removal - Lexmark MX610 Service Manual

Stapler cooling fan removal

1
Remove the stapler right cover. See
2
Remove the stapler left cover. See
3
Remove the stapler rear cover. See
4
Remove the stapler service cover. See
5
Disconnect the cooling fan cable CN8 from the controller card.
6
Remove the four screws (A) from the cooling fan.
7
Route the cable off the stapler, and remove the cooling fan.
Note: Pay attention to the original routing of the cable.

Stapler power supply unit removal

1
Remove the stapler right cover. See
2
Remove the stapler left cover. See
3
Remove the stapler rear cover. See
4
Remove the stapler cooling fan. See
5
Remove the stapler service cover.
6
Disconnect the power supply cable CN5 from the controller card.
"Stapler right cover removal" on page
"Stapler left cover removal" on page
"Stapler rear cover removal" on page
"Stapler service cover removal" on page
"Stapler right cover removal" on page
"Stapler left cover removal" on page
"Stapler rear cover removal" on page
"Stapler cooling fan removal" on page
Repair information
372
355.
356.
364.
368.
355.
356.
364.
372.
7016