Perkins M300TI Installation Manual page 16

Chapter 3 TPD1317e
In order to achieve sufficient height above the waterline it may be necessary to use the system shown in
Figure 2. This also enables the two elbows to be rotated relative to each other to allow the exhaust hose to
run towards the side of the boat. The arrangement shown raises the exhaust height above the turbocharger
outlet by about 230mm (9 inches) - greater heights can be achieved if necessary by using the arrangement
described in Section 3.3.
Elbow with facility for
water injection
Insulating blanket
Possible
rotation
Dry elbow
Figure 2 - High rise exhaust elbow.
Page 12