Lexmark E460dn User Manual page 96

Menu item
"+ @@NAOO
<xxx>.<xxx>.<xxx>.<xxx>
"+ +API=OG
<xxx>.<xxx>.<xxx>.<xxx>
"+ $=PAS=U
<xxx>.<xxx>.<xxx>.<xxx>
-=N=HHAH IAJQ
Menu item
- ) 0I=NP0SEP?D
On
Off
-0 0I=NP0SEP?D
On
Off
+- *K@A
On
Off
Auto
Description
Sets the network address information for an external print server that is attached to
the printer using a USB cable
Note: This menu item is available only if the printer is attached to an external print
server through the USB port.
Sets the netmask information for an external print server that is attached to the
printer using a USB cable
Note: This menu item is available only if the printer is attached to an external print
server through the USB port.
Sets the gateway information for an external print server that is attached to the
printer using a USB cable
Note: This menu item is available only if the printer is attached to an external print
server through the USB port.
Description
Sets the printer to automatically switch to PCL emulation when a print job received
through a USB port requires it, regardless of the default printer language
Notes:
On is the factory default setting.
•
When the Off setting is used, the printer does not examine incoming data.
•
When the Off setting is used, the printer uses PostScript emulation if PS
•
SmartSwitch is set to On. It uses the default printer language specified in the
Setup menu if PS SmartSwitch is set to Off.
PCL SmartSwitch is shown only if the PostScript level is non-zero.
•
Sets the printer to automatically switch to PS emulation when a print job received
through a USB port requires it, regardless of the default printer language
Notes:
On is the factory default setting.
•
When the Off setting is used, the printer does not examine incoming data.
•
When the Off setting is used, the printer uses PCL emulation if PCL SmartSwitch
•
is set to On. It uses the default printer language specified in the Setup menu if
PCL SmartSwitch is set to Off.
PS SmartSwitch is shown only if the PostScript level is non-zero.
•
Sets the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol
Notes:
Auto is the factory default setting.
•
Changing this setting from the printer control panel and then exiting the menus
•
causes the printer to restart. The menu selection is updated.
2J@ANOP=J@EJC LNEJPAN IAJQO