Lexmark E460dn User Manual page 103

Menu item
.QEAP *K@A
Off
On
/QJ &JEPE=H OAPQL
Yes
No
-=LAN 0EVAO
US
Metric
H=NIO
Cartridge Alarm
Off
Single
1EIAKQPO
Power Saver
1min–240 min
1EIAKQPO
Screen Timeout
15 sec–300 sec
Description
Reduces the amount of noise produced by the printer
Notes:
Off is the factory default setting.
•
On configures the printer to produce as little noise as possible.
•
Instructs the printer to run the setup wizard
Notes:
Yes is the factory default setting.
•
After completing the setup wizard by selecting Done at the
•
country or region select screen, the default setting becomes
No.
Sets paper sizes to use the standard US sizes, which may also be
used in other countries, or to use metric sizes
Notes:
US is the factory default setting.
•
Changing this setting also changes the Units of Measurement
•
setting in the Univeral Setup menu and the default size value
for each paper source (tray or feeder) in the Paper Size/Type
menu.
Sets an alarm to sound when the printer requires operator
intervention
Notes:
Off is the factory default setting for Cartridge Alarm. Off means
•
no alarm will sound. Cartridge low appears on the
display.
Single sounds three quick beeps. 88 Cartridge is
•
low appears on the display.
Sets the amount of time the printer waits after a job is printed
before it goes into a reduced power state
Notes:
30 minutes is the factory default setting.
•
Lower settings conserve more energy, but may require longer
•
warm-up times.
Select the lowest setting if the printer shares an electrical
•
circuit with room lighting or you notice lights flickering in the
room.
Select a high setting if the printer is in constant use. Under
•
most circumstances, this keeps the printer ready to print with
minimum warm-up time.
Sets the amount of time in seconds the printer waits before
returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
2J@ANOP=J@EJC LNEJPAN IAJQO