Lexmark E460dn User Manual page 38

5 Press the down arrow button until Units of Measure appears, and then press
6 Press the down arrow button until
Submitting selection appears, followed by the Universal Setup menu.
0LA?EBU PDA L=LAN DAECDP =J@ SE@PD
Defining a specific height and width measurement for the Universal paper size (in the portrait orientation) allows
the printer to support the size, including support for standard features such as duplex printing and printing multiple
pages on one sheet.
Note: Select Portrait Height to adjust the paper height setting or Paper Width to adjust the paper width
setting, or adjust both. Instructions to adjust both follow.
1 From the Universal Setup menu, press the down arrow button until
press .
Press the left arrow button to decrease the setting or the right arrow button to increase the setting, and then
2
press .
Submitting selection appears, followed by the Universal Setup menu.
From the Universal Setup menu, press the down arrow button until Portrait Height appears, and then
3
press .
Press the left arrow button to decrease the setting or the right arrow button to increase the setting, and then
4
press .
Submitting selection appears, followed by the Universal Setup menu.
5 Press and release
0LA?EBU = BAA@ @ENA?PEKJ
Short Edge is the factory default setting for feed direction for Universal paper settings. The Feed Direction menu will
not appear from the Universal Setup menu unless Long Edge is an available setting. If necessary, specify whether the
short or long edge of the paper will enter the printer first.
From the Universal Setup menu, press the down arrow button until Feed Direction appears, and then press
1
.
Press the down arrow button until Short Edge or Long Edge appears, and then press
2
)K=@EJC PN=UO
1 Pull the tray completely out.
Note: Do not remove trays while a job prints or while Busy appears on the display. Doing so may cause a jam.
appears next to the correct unit of measure, and then press
until Ready appears.
)K=@EJC L=LAN =J@ OLA?E=HPU IA@E=
Portrait Width appears, and then

.
.
.