Lexmark E460dn User Manual page 87

Menu item
-KNPN=EP 4E@PD
3–14.17 inches
76–360 mm
-KNPN=EP %AECDP
3–14.17 inches
76–360 mm
#AA@ !ENA?PEKJ
Short Edge
Long Edge
/ALKNPO IAJQ
/ALKNPO IAJQ
To print a report, use the arrow buttons to navigate to the type of report you want, and then press
Menu item
*AJQ 0APPEJCO -=CA
!ARE?A 0P=PEOPE?O
+APSKNG 0APQL -=CA
Description
Sets the portrait width
Notes:
If the width exceeds the maximum, then the printer uses the
•
maximum width allowed.
8.5 inches is the US factory default setting. Inches can be increased
•
in 0.01-inch increments.
216 mm is the international factory default setting. Millimeters can
•
be increased in 1-mm increments.
Sets the portrait height
Notes:
If the height exceeds the maximum, then the printer uses the
•
maximum height allowed.
14 inches is the US factory default setting. Inches can be increased in
•
0.01-inch increments.
356 mm is the international factory default setting. Millimeters can
•
be increased in 1-mm increments.
Specifies the feed direction
Notes:
Short Edge is the factory default setting.
•
Long Edge appears only if the longest edge is shorter than the
•
maximum length supported in the tray.
Description
Prints a report containing information about paper loaded into trays, installed
memory, the total page count, alarms, timeouts, the printer control panel
language, the TCP/IP address, the status of supplies, the status of the network
connection, and other information
Prints a report containing printer statistics such as supply information and
details about printed pages
Prints a report containing information about the network printer settings, such
as the TCP/IP address information
Note: This menu item appears only for network printers or printers connected
to print servers.
2J@ANOP=J@EJC LNEJPAN IAJQO

.