Lexmark E460dn User Manual page 37

)K=@EJC L=LAN =J@ OLA?E=HPU IA@E=
This section explains how to load the 250- and 550-sheet trays and the multipurpose feeder. It also includes
information about paper orientation, setting the Paper Size and Paper Type, and linking and unlinking trays.
0APPEJC PDA -=LAN 0EVA =J@ -=LAN 1ULA
When the Paper Size and Paper Type settings are the same for any trays, the trays are automatically linked.
Note: If you load a tray with paper that is the same size as the paper that was previously loaded in the tray, you do
not need to change the Paper Size setting.
1 Make sure the printer is on and Ready appears.
From the printer control panel, press
2
Paper Menu appears.
3 Press .
Press the up or down arrow button until Paper Size/Type appears, and then press
4
Press the up or down arrow button until the correct tray or feeder appears, and then press
5
6 Press the left or right arrow button until the correct size appears, and then press
Paper Type appears.
7 Press the left or right arrow button until the correct type appears, and then press
Submitting selection appears, followed by Paper Size/Type.
KJBECQNEJC 2JERANO=H L=LAN OAPPEJCO
The Universal Paper Size is a user-defined setting that lets you print on paper sizes that are not preset in the printer
menus. Set the Paper Size for the specified tray to Universal when the size you want is not available from the Paper
Size menu. Then, specify all of the following Universal size settings for your paper:
Units of measure (inches or millimeters)
•
Portrait Height and Portrait Width
•
Feed Direction
•
Note: The smallest supported Universal size is 76.2 x 127 mm (3 x 5 in.); the largest is 216 x 356 mm (8.5 x 14 in.).
0LA?EBU = QJEP KB IA=OQNAIAJP
1 Make sure the printer is on and Ready appears.
From the printer control panel, press
2
Paper Menu appears.
3 Press .
4 Press the down arrow button until Universal Setup appears, and then press
.
.
)K=@EJC L=LAN =J@ OLA?E=HPU IA@E=

.
.
.
.
.