Ebode IPV68P2P User Manual page 8

This camera supports I/O alarm, go to Settings – Alarm – I/O page to configure it.
2) Audio output interface
The jack is used to plug external speakers.
3) Power Interface
Connect the external power adapter, request for 12V/2A power.
4) Audio input interface
The jack is used to plug external microphone.
5) LAN
10/100M adaptive Ethernet interface. Through this interface, IPCAM can be connected
with various network devices, such as hub, router, etc.
6) Reset button
Press and hold on the reset button for 5 seconds. Releasing the reset button, the
password will back to the factory default administrator password. The default
administrator user is admin with no password.
Bottom View
There are up to three labels located on the body of the camera; this is an important
feature of original cameras. If your camera does not have labels as shown in Figure 7.5,
it may be a clone one. Cloned cameras cannot use original firmware and are not eligible
for warranty or technical services.
24-9-2015
Figure 7.4
Figure 7.5
8 ebode IPV68P2P