System - Ebode IPV68P2P User Manual

Enable firewall, If you select Only allow access from these IP addresses and fill in 8 IP
addresses at most, only those clients whose IP addresses listed in the Only allow access
from these IP addresses can access the Network Camera. If you select Block access from
these IP addresses, only those clients whose IP addresses are in the IP list cannot access
the Network Camera.
Click Save to take effect.

10.9 System

In this panel, you can backup/restore your camera settings, upgrade the firmware to the
latest version, restore the camera to default settings and reboot the device.
10.9.1 Back-up & Restore
Click Back-up to save all the parameters you have set. These parameters will be stored
in a bin file for future use.
Click Browse and select the parameters file you have stored, then click Submit to restore
the restore the parameters.
10.9.2 System Upgrade
Your current firmware version will be displayed on your screen. You may go to the
Device Status  Device Information Page to check for the latest firmware versions
available.
Click Browse, choose the correct bin file and then click System upgrade. Make sure you
have unplugged the SD card. Don't shut down the power during upgrade. After
upgrading, you can see the upgrade result.
Upgrade Firmware by IP Camera Tool
24-9-2015
Figure 10.80
Figure 10.81
66 ebode IPV68P2P