Advanced Camera Settings; Status - Ebode IPV68P2P User Manual

Click the Screen PTZ button and put the mouse on the screen to indicate the camera
move direction you prefer, press the left mouse, the camera will move to the
corresponding direction. Loosen the mouse and stop moving. Press Esc button or double
click right mouse and cancel the function. Please note that for Mac OS, the plugin cannot
support Onscreen Mouse Control, so you cannot allow to use it.

10. ADVANCED CAMERA SETTINGS

Click the button "Settings", goes to Administrator Control Panel to make advanced
camera settings.

10.1 Status

Status contains four columns: Device Information, Device Status, Session Status and
Log, it will show you various information about your camera.
10.1.1 Device Information
Camera Model: The model of the device.
Camera Name: The Device Name is a unique name that you can give to your device to
help you identify it. Click Basic Settings and go to Camera name panel where you can
change your camera name. The default device name is anonymous.
Camera ID: Display the wired MAC address of your camera. For example Device ID is
HJYFC8613P03, the same MAC ID sticker is found at the bottom of the camera.
Camera Time: The system time of the device. Click Basic Settings and go to Camera
time panel and adjust the time.
System Firmware version: Display the System Firmware version of your camera.
App Firmware version: Display the application firmware version of your camera.
Plug-in version: Display the plug-in version of your camera
10.1.2 Device Status
On this page you can see device status such as Alarm status/ Record Status ,DDNS
status ,WIFI status and so on.
24-9-2015
Figure 10.1
Figure 10.2
28 ebode IPV68P2P