Spirit 161168395US Owner's Manual page 9

STEP 2: Console Mast
Slide the Computer Cable (44), Handlebar Resistance Control Cable (148), and Hand
1.
Pulse Cable (45) through the bottom of the Console Mast Cover (31) and then the
bottom of the Console Mast (2). Make sure the Console Mast Cover is correctly oriented
(see illustration).
Install the Console Mast (2) into the receiving tube (make sure not to pinch cables;
2.
damage to the electronics could occur) of the Main Frame (1). Insert two Hex Head Bolts
(68) and two Flat Washers (76) on each side. Insert two Hex Head Bolts and two Curved
Washers (83) on the front. Tighten all six bolts firmly with the Wrench (112).
Remove the white styrofoam pad (factor y installed to prevent bolts from being
3.
accidentally dropped into the Console Mast Tube).
Attach the Handle Bar Assembly (3) onto the Console Mast (2) bracket with the two Hex
4.
Head Bolts (68), two Split Washers (82), and two Flat Washers (76). Completely tighten
with the Wrench (112).
Insert the Computer Cable (44), Handlebar resistance control cable (148), and Hand
5.
Pulse Cable (45) into their respective connectors in the back of the Console Assembly
(19). Attach the console onto the mounting plate with four Phillips Head Screws
(99).Tighten with the Phillips Head Screw Driver (114).
HARDWAR
#82. 5/16" x 1.5T #83.5/16" x 19 x 1.5T
Split Washer Cur ved Washer
(2 pcs) (2 pcs)
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
#76.5/16" x 18 x
1.5T Flat Washer
(6 pcs)
8
#68.5/16" x 5/8"
Hex Head Bolt
(8pcs)
Dyaco Canada Inc. 2014
#99.M5 x 12mm
Phillips Head Screw
(4 pcs)