Table of Contents
Advertisement
General Maintenance
1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of
two reasons:
The hardware was not sufficiently tightened during assembly. All bolts that were
I.
installed during assembly need to be tightened as much as possible. It may be
necessary to use a larger wrench than the one provided if you cannot tighten the
bolts sufficiently. I cannot stress this point enough; 90% of calls to the ser vice
department for noise issues can be traced to loose hardware.
The crank arm nut needs to be retightened
II.
If squeaks or other noises persist, check that the unit is properly leveled. There are
III.
2 leveling pads on the bottom of the rear stabilizer, use a 14mm wrench (or
adjustable wrench) to adjust the levelers.
Engineering Mode Menu
The console has built in maintenance/diagnostic software. The software will allow you to
change the console settings from English to Metric and turn off the beeping of the speaker
when a key is pressed for example. To enter the Engineering Mode Menu, press and hold
down the Start, Stop and Enter keys. Keep holding the keys down for about 5 seconds
and the Message
Center will display Engineering Mode Menu. Press the Enter button to access the menu
below:
a. Key Test (Will allow you to test all the keys to make sure they are functioning)
b. Security (Allows the keypad to be locked to prevent unauthorized use)
c. Functions (Press Enter to access settings and Up arrow to scroll)
i. Sleep Mode (Turn on to have the console power down automatically
after 20 minutes of inactivity)
ii. DA Test (Tests the brake resistance)
iii. Beep (Turns off the speaker so no beeping sound is heard)
iv. Units (Sets the display to readout in English or Metric display measurements)
v. ODO Reset (Resets the odometer)
vi. Pause Mode (Turn on allow 5 minutes of pause, turn off to have the
console pause indefinitely)
d. LCD Test (Tests all the display functions)
Customer Service 1-888-707-1880
Email:
customerservice@dyaco.ca
30
Dyaco Canada Inc. 2014
Advertisement
Table of Contents
