Spirit 161168395US Owner's Manual page 11

STEP 4: Plastic Parts
1. Put the Seat Recline Release Cable (58) on the U Bracket of the Seat Back Frame (5).
2. Install the Gas Cylinder (57) on the Seat Back Frame (5) with one Hex Head Bolt (70), one
Flat Washer (76) and one Nyloc Nut (91) by using the Wrenches provided (112 & 113).
3. Remove the Button Head Socket Screws holding the clamps of the left and right Release
Levers (40) by using the Allen Wrench (115). Install the Release Levers (40) onto the Seat
Handle Bars (6) just behind the Hand pulse sensors on each side. Install them at an angle
that allows easy access for use, then reinsert and tighten the socket screws removed
earlier. Don't over tighten these screws.
4. Secure the Steel Cables (58 & 59) to the Seat Handle Bar (6) with two pieces of Velcro
Tape. Wrap the tape around the handlebars in places that will be under the beverage
holders so they are out of sight.
5. Attach the Pedals (116L, 117R) to the Crank Arms (51L, 51R).Tighten with the Wrench
(113). Remember that the left pedal has a reverse thread and will be threaded onto the
Crank arm in a counterclockwise motion. There is an "L" stamped in the end of the
threaded post of the left pedal and an "R" in the right. Make sure to tighten the pedals as
firmly as you can. It may be necessary to re-tighten the pedals if you feel a thumping while
pedaling the bike. A thumping or clicking noise is usually caused by loose pedals.
6. Attach the Drink Bottle Holders (39L & 38R) to the sides of the Seat Handle Bar (6) with
four Sheet Metal Screws (105).Tighten with the Phillips Head Screw Driver (114)
HARDWARE
#76.5/16" x 18 x 1.5T
Flat Washer (1 pc)
Customer Service 1-888-707-1880
Email: customerservice@dyaco.ca
#91.5/16" x 6T
Nyloc Nut (1 pc)
10
#105.Ø4 x 16mm
Sheet Metal Screw (4 pcs)
#70.5/16" x 1-1/4"
Hex Head Bolt (1 pc)
Dyaco Canada Inc. 2014