Table of Contents
Advertisement
STEP 1: Rear Stabilizer & Seat Back
Attach the Rear Stabilizer (7) to the Main Frame (1) with the two Hex Head Bolts (65)
1.
and two Flat Washers (84) and two Cap Nuts (191).Tighten completely with the Wrench
(112).
Attach the Seat Back (5) to the Seat Carriage (4) of the main frame. Slide a Hex Head
2.
Bolt (67) through each side, then attach a Nyloc Nut (89) to each bolt. Tighten the bolts
just enough so there is no side to side play, but freedom of movement front to back. Use
the Wrenches provided (112 & 130).
Insert an end cap (32) into each opening of the Front Stabilizer Tube. You may need to
3.
tap them in with a rubber mallet if they are tight.
HARDWARE
#65. 3/8" x 53mm
Carriage Bolt Bolt
(2 pcs)
#89.3/8" x 7T
Nyloc Nut (2 pcs)
Customer Service 1-888-707-1880
Email:
customerservice@dyaco.ca
#67. 3/8" x 4"
Hex Head Bolt (2 pcs)
#84.3/8" x 25 x 2T
Flat Washer (2 pcs)
#191.3/8"
Cap Nut (2 pcs)
7
Dyaco Canada Inc. 2014
Advertisement
Table of Contents
