Panel Installation / Removal; Installation; Removal - Pacific energy BRISTOL Installation And Operating Instructions Manual

NOTE: Air De ector from burner kit needs to be installed before panels. See Burner Kit Installation.

Installation

1. Insert back panel so that it is sitting on ledge at the back of the rebox as shown in Figure 58.
2. Insert rst side panel by inserting the front edge of the panel into the lip at the front of the rebox. Then
slide the back of the panel until it reaches the rebox side wall (Figure 59).
3. Repeat steps 2 for the second side panel.
4. To hold panels in place, install the baffle, from the burner kit, by resting the back ange on top of the back
panel and use two screws to secure the front of the baffle to the top of the rebox, seen in Figure 61.

Removal

1. Remove the baffle by removing screws securing the front edge of the baffle seen in Figure 61. After
removing the two screws you can slide the baffle out of the replace.
2. Remove rst side panel by pulling the back edge
of panel (Figure 59) out away from the rebox wall
until there is enough room to remove the front
edge of the panel from the lip at front of rebox.
When you have enough room, remove panel's front
edge from the rebox lip and remove from re-
place.
Figure 57: Panel set.
5055.633-B

Panel Installation / Removal

Figure 58: Rear panel.
Figure 59: Side panel.
32
BRSL.BODYB
050216-44
BDFD.BODYB