Toshiba E-studio 210c Imaging Manual page 49

(2) Enter adjustment mode [05] and change the set value for code [779 to 798] to adjust the density of each
color.
Color to be Original
adjusted mode
Text/photo
Text
Y
Printed image
(yellow)
Photo
Map
Text/photo
Text
M
Printed image
(magenta)
Photo
Map
Text/photo
Text
C
Printed image
(cyan)
Photo
Map
Text/photo
Text
K
Printed image
(black)
Photo
Map
* Set the value in about 10 increments while checking the copy until the optimum value is obtained.
* The subcode varies according to the area for which the density is adjusted. Enter the code for the area to
be adjusted by referring to the table below.
Subcode
0
1
2
Cautions after the completion of the adjustment
The adjustment may possibly cause the hues of areas (photo, text, etc.) other than those written with highlighter
pens to change. Therefore, perform the adjustment carefully, while checking the printout.
Remarks
Enter the value within the recommended value range mentioned in the procedures. Otherwise, it may cause a
loss in copier performance, such as image failure.
[05] code Subcode*
05-779
05-780
05-781
05-782
05-783
05-784
05-785
05-786
05-787
05-788
05-789
05-790
05-791
05-792
05-793
05-794
05-795
05-796
05-797
05-798
Area for the density to be adjusted
Low-density area
Medium-density area
High-density area
2. Copier-specific Adjustments
Value recommended
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
To increase the density:
0/1/2
Make it greater than 128.
0/1/2
0/1/2
To decrease the density:
0/1/2
Make it less than 128.
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
e-STUDIO210c/310c, e-STUDIO211c/311c
Default
128
2.11