Safety Instructions; Connection To Power Supply; Overcurrent Protection - OneAccess ONE100 Installation Manual

Safety Instructions

1
The following symbol instructs the user to read the manual carefully before any
connection:
1.1

Connection to Power Supply

To connect the power supply, always follow these steps:
•
Connect the DC input jack from the power supply to the DC 12V power input
on the rear panel of the router,
•
Connect the power supply to an AC electrical outlet (200-240 VAC). Plugging
in the power supply turns on the router.
Unplug the AC input before assembling/disassembling any part on the
device. The AC input is the part you must disconnect first. For safety rea-
sons, you shall be able to easily access this part.
1.2

Overcurrent Protection

The product requires that the building's electrical installation is designed for
protection against short-circuit (over current) protection.
A fuse or circuit breaker no larger than 240 VAC, 10A must be used on the phase
conductors.
5
ONE100 - Installation Manual