Subscribe to Our Youtube Channel
Related Manuals for OneAccess ONE80
Summary of Contents for OneAccess ONE80
- Page 1 ONE80 Installation Manual Version B April 2007 http://www.oneaccess-net.com ONE80 – Installation Manual...
- Page 2 OneAccess. OneAccess and the distributors can in no case be held responsible for direct or indirect damage of any kind incurred as a result of any error in the software or guide.
-
Page 3: How To Read This Manual
This section describes technical characteristics such as operating conditions. Chapter 7 – Directives and Standards This chapter details the list of standards, which the device complies with. Appendix – Connection Description This chapter provides the pin-out of cables that are compatible with the router. ONE80 – Installation Manual... -
Page 4: Table Of Contents
LAN 10/100 Mbps interface (ETHERNET)....................15 Switch Interface (SWITCH) ........................16 INSTALLATION............................17 Connection ...............................17 POWER-UP ..............................18 TECHNICAL CHARACTERISTICS ......................19 Climatic Environment ..........................19 Power Supply ............................19 Dimensions...............................19 DIRECTIVES AND STANDARDS ......................20 Declaration of Conformity ........................20 Standards ..............................21 ANNEXE A: CONSOLE CABLE..........................23 ONE80 – Installation Manual... -
Page 5: Safety Instructions
All safety levels of the interfaces are described in each paragraph presenting the interfaces (paragraphs 3.1 to 3.4). The interface modules and optional boards can be installed only in the products authorized by OneAccess and only by qualified staff as recommended in the installation manual. ONE80 – Installation Manual... -
Page 6: Directives And Standards
Directives and Standards Declaration of Conformity ONE80 – Installation Manual... -
Page 7: Standards
Standards The ONE80 is designed in conformity with the standards listed hereafter, provided that the basic housing, modules, interface boards and installation kits are mounted as recommended in the corresponding installation manual(s). Safety EN60950-1: 2001, First Safety of information technology equipment, including electrical Edition business equipment. -
Page 8: Router Description
Router Description Hardware Description This section details the various types of services offered by the ONE80. The described configurations are the maximum configurations for the motherboard and the extension modules. Other configurations can be derived by under-equipment. Indeed, the ONE80 can have fewer interfaces compared to those presented below. -
Page 9: Front Panel
At least one interfaces are are down IP Interface is not up (example: PPPoA not connected) WLAN Not used Interface up Traffic in progress No auto Auto Auto configurat configuration configuratio successfully n in completed progress ONE80 – Installation Manual... -
Page 10: Rear Panel
Rear Panel This section details the various types of ONE80 rear panel so that the user can identify the interface type and port numbering. It should be noted that only the fully-loaded configurations are represented. Other configurations can be derived by not providing some interfaces represented on the product. - Page 11 4 FastEthernet switch ports (RJ45) (SWITCH E3-0/3 to E0-0/0), • Input for the external power supply connector (DC input jack, 12V-1.7A), • 2 connectors for WLAN antenna. Figure 2. Rear panel Depending of the ordered configuration of the system, the rear panel may change. ONE80 – Installation Manual...
-
Page 12: Configuration Identification
D: G.SHDSL access 1 to 2 pairs (2 to 4 wires), • M: IMA access G.SHDSL 4 pairs (8 wires), • W: Wireless LAN Example: ONE80 M is an ONE80 router equipped with: • 1 IMA access G.SHDSL 8 wires. ONE80 – Installation Manual... -
Page 13: Interface Description
Signal Signal Line 2 Line 1 Line 2 Line 3 Line 3 Line 4 Line 1 Line 4 4.1.4 Cables For the connection of the G.SHDSHL interface, use the shielded cable that comes with the equipment. ONE80 – Installation Manual... -
Page 14: Console Interface (Console)
8 bits, 1 bit for stop, no parity. 4.2.2 Connector Pinout RJ45 connector: Signal Signal • TX: Emission • RX: Reception • NC: Not Connected • GND: Ground 4.2.3 Cable The console cable is defined in Appendix A. ONE80 – Installation Manual... -
Page 15: Lan 10/100 Mbps Interface (Ethernet)
TD (-) RD (-) RD (+) 4.3.5 Cables The cables are shielded, crossover/straight cables with 4 twisted pairs. The switch supports auto detection of crossover/straight cable (’auto-MDI/MDI-X detection’); the transmission pairs are (1-2) and receive (3-6). ONE80 – Installation Manual... -
Page 16: Switch Interface (Switch)
TD (-) RD (-) RD (+) 4.4.5 Cables The cables are shielded, crossover/straight cables with 4 twisted pairs. The switch supports auto detection of crossover/straight cable (’auto-MDI/MDI-X detection’); the transmission pairs are (1-2) and receive (3-6). ONE80 – Installation Manual... -
Page 17: Installation
• Secure the power supply connection by installing the DC power supply cord into the plastic ring. The device shall not be used with another power supply than a power supply provided by OneAccess. ONE80 – Installation Manual... -
Page 18: Power-Up
The ’STATUS’ LED light remains steady green if software initialization was successful, • The ’STATUS’ LED blinks in case of software absence or error during software loading. Refer to the Software and ONEOS User Guide for more information. ONE80 – Installation Manual... -
Page 19: Technical Characteristics
≤ 24g / m3 Absolute Humidity ≤ 2500 m Altitude Power Supply External Power Supply 100-240 VAC / 20W (12V – 1,7A). Dimensions The dimensions of the housing are: 320 mm Width Height 200 mm Depth ONE80 – Installation Manual... -
Page 20: Directives And Standards
Directives and Standards Declaration of Conformity In progress ONE80 – Installation Manual... -
Page 21: Standards
Standards The ONE80 is designed in conformity with the standards listed hereafter, provided that the basic housing, modules, interface boards and installation kits are mounted as recommended in the corresponding installation manual(s). Security EN60950-1:2001 Safety of information technology equipment, including electrical First Edition business equipment. - Page 22 EN covering essential requirements under article 3.2 of the R&TTE Directive Waste Electrical and Electronic Equipment The ONE80 respects the European directive on the waste disposal 2002/96/EC from the electric and electronic equipment. Restricted use of Hazardous Substances (RoHS)
-
Page 23: Annexe A: Console Cable
Annexe A: Console Cable Catalog reference: 4 022 332 B 00 Ed A To PC serial port in terminal mode (Configuration) RJ45 - P1 SIGNAL SUB-D 9 Pts Female - P2 ONE80 – Installation Manual...
Need help?
Do you have a question about the ONE80 and is the answer not in the manual?
Questions and answers