Panasonic AJ-PX380G Operating Instructions Manual page 165

f [UBG]: User bits value
During playback, [UBR] is displayed.
f [VUBG]: User bits value of VITC
During playback, [VUBR] is displayed.
@ NOTE
t Display status of the counter value is held even when the power is turned off.
t For [TCG] and [UBG], if they are locked to the input signal from the <TC IN/OUT> terminal, [TCG] and [UBG] are displayed in white letters with
outlines.
t The time code during playback with 24PN is displayed converted into 30 frames.
2 Frame rate display
Shows the number of recording/playback frames.
3 Proxy information display
Displays the proxy recording information.
f [PROXY P2]/[PROXY P2&SD]: Displayed when proxy recording is started.
f [PROXY ERR]: Displayed when there is an error in proxy recording.
4 SD memory card status display
f [WP]: Write protected
f [END]: No remaining free space
f [WR ERR]: Write error
f [SD ***min]: The remaining free space is displayed when proxy is recorded to an SD memory card. (Displayed only in the regular mode check.)
Flashing when the remaining capacity is one minute or less. [−−min] is displayed when there is no SD memory card.
5 System mode display
Displays the mode in which the camera is operating.
f [1080-59.94P]
f [1080-59.94i]
f [1080-50P]
f [1080-50i]
f [1080-23.98PsF]
f [720-59.94P]
f [720-50P]
f [480-59.94i]
f [576-50i]
6 Recording format display
Displays the recording method.
f [AVC-I100]
f [AVC-I50]
f [AVC-G50]
f [AVC-G25]
f [AVC-G12]
f [DVCPRO HD]
f [DVCPRO50]
f [DVCPRO]
f [DV]
7 Letterbox recording display
Displayed while letterbox recording is performed when the recording format is 480i/576i and [LETTER BOX] is set in the main menu → [SYSTEM
MODE] → [ASPECT CONV].
8 Streaming mode status display
Displays the streaming status.
Displayed only when the <DISP/MODE CHK> switch is pushed towards the <CHK> side.
f [STREAM]: When the streaming mode is set and enabled
f [STRM ]: When the streaming mode is set but cannot operate due to other setting condition
f No display: When the streaming mode is not set
9 Network mode status display
Displays the status of the network function.
Displayed only when the <DISP/MODE CHK> switch is pushed towards the <CHK> side.
f [WLAN]: When the wireless LAN is connected (link state)
f [WLAN ]: When the wireless LAN is not connected (unlinked state)
f [WLAN ]: When there is a problem with the wireless LAN connection
f [LAN]: When the wired LAN is connected (link state)
f [LAN ]: When the wired LAN is not connected (unlinked state), or when there is a problem
f [4G/LTE]: During 4G/LTE connection
f [4G/LTE ]: When 4G/LTE connection is set but not connected
f [4G/LTE ]: When 4G/LTE connection is set but 4G/LTE USB modem is not connected or not operating correctly
f No display: When the network function is disabled
Chapter 8 Display — Screen status display
– 165 –