Table of Contents
Advertisement
Appendix D Option Units
2.4 Hard Disk
Insert the hard disk into its slot on the main circuit board of the
printer. If a hard disk unit is installed in the printer, received data
can be rasterized and stored on this hard disk. This enables
high-speed printing of multiple copies using an electric sort func-
tion. Also, you can use the e-MPS functions. For details, see
MPS on page
3-11.
For details of available hard disk, see your dealer.
1
Turn off the printer and disconnect the power cord and
printer cable.
2
Remove the two screws and remove the slot cover
(OPT1/HDD).
3
Insert the optional hard disk unit into the slot.
4
Tighten the two screws to secure the hard disk unit to
the main circuit board.
D-4
2.5 Memory Card
Insert the memory card into the memory card slot located the
right side of the printer. A memory card is a microchip card that
may contain option fonts, macros, forms, etc. The printer reads
the contents of the card into its internal memory when printer is
e-
turned on.
For details of available memory cards, see your dealer.
1
Turn off the printer.
NOTE
Do not insert or remove a memory card while power is
on. If the memory card is removed while the printer is
on, damage could result in the printer's electronics or
the memory card.
2
Insert the memory card in the slot. Insert it as its label
surface facing toward outside, connector end first. Push
it in all the way.
Advertisement
Chapters
Table of Contents
