Using Page Set Menus; Internal Fonts - Kyocera Mita FS-9500DN Operation Manual

5
Press the 3 or 4 key repeatedly until >Pitch ap-
pears.
>Pitch
10.00 cpi
6
Press the ENTER key. A blinking cursor ( _ ) appears.
>Pitch
10.00 cpi
7
Press the 3 or 4 key to increase or decrease the value
of the figure where the cursor is blinking. The character
pitch can be set between 0.44 and 99.99 characters
per inch, in 0.01 character-per-inch increments. You
can use the 2 and 1 keys to move the cursor right and
left.
8
When the desired size is displayed, press the ENTER
key.
9
Press the MENU key. The message display returns to
Ready.
Printing a List of Fonts
To help in selecting fonts, you can print a list of the fonts includ-
ing option fonts.
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Font > appears.
Font
3 Press the 2 key.
4
Press the 3 or 4 key repeatedly until List of In-
ternal Fonts appears. List of Option Fonts
appears.

(Internal Fonts)

>List of
Internal Fonts
(Optional Fonts)
>List of
Option Fonts
>
Chapter 3 Using the Operator Panel
5
Press the ENTER key. A question mark (?) appears.
(Internal Fonts)
>List of
Internal Fonts?
(Optional Fonts)
>List of
Option Fonts ?
6
Press the ENTER key again. Processing appears,
then Ready. The printer prints a list of fonts with a short
sample and font ID (number) for each font.

2.2.7 Using Page Set Menus

In Page Set menus, you can set the number of copies, the page
orientation, and other settings regarding pagination.
Setting the Number of Copies
You can set the number of copies to be printed of each page for
the current interface. The number of copies can be set between
1 and 999. The number of copies can be set whenever the mes-
sage display indicates Ready.
1
Press the MENU key.
List of Fonts
3-26