Setting The Print Quality; Ecoprint Mode - Kyocera Mita FS-9500DN Operation Manual

6
Select On or Off using the 3 or 4 key.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.

2.2.8 Setting the Print Quality

You can make the following settings to enhance the print quality:
Kyocera Image Refinement (KIR), a software algorithm for in-
creasing printout quality; EcoPrint, a printing mode that reduces
toner consumption during printing; printing resolution; and Ad-
justment of the Print Density.
KIR (Kyocera Image Refinement)
This printer incorporates the KIR (Kyocera Image Refinement)
smoothing function. At resolution of 600 dpi this function pro-
vides high print quality by providing software enhancement of
print resolution.
With KIR Off
NOTE
Set the print density to 3 when setting the KIR mode. For details
on print density, see page
pattern, the last line on a status page, to make the optimum KIR
mode setting.
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until Print Quali-
ty > appears.
Print Quality
3
Press the 2 key.
4
Press the 3 or 4 key repeatedly until >KIR Mode ap-
pears.
>KIR Mode
On
With KIR On (default)
3-31. You can monitor the KIR test
>
Chapter 3 Using the Operator Panel
5
Press the ENTER key. A blinking question mark (?) ap-
pears.
>KIR Mode
? On
6
Select On or Off using the 3 or 4 key.
7
Press the ENTER key.
8
Press the MENU key. The message display returns to
Ready.
EcoPrint
The EcoPrint enables you to reduce the amount of toner con-
sumed on the page so as to save your printing costs. You can
set EcoPrint mode On, as follows. (The factory default setting is
Off. ) The EcoPrint mode setting is On when the printing image
becomes lighter, yet very readable.
EcoPrint setting is Off
(default)
NOTE
The EcoPrint setting has no effect on the print speed.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Print Quali-
ty > appears.
Print Quality
3 Press the 2 key.
4
Press the 3 or 4 key repeatedly until >EcoPrint
Mode appears.
>EcoPrint Mode
Off
EcoPrint setting is On
>
3-30