Kyocera Mita FS-9500DN Operation Manual page 48

2 Press the 3 or 4 key repeatedly until Hard Disk >
appears.
Hard Disk
3
Press the 2 key.
4 Press the 3 or 4 key repeatedly until >Read Data ap-
pears. The data name also appears.
>Read Data
DataH001
5
Press the ENTER key. A blinking question mark (?) ap-
pears before the data name.
>Read Data
?DataH001
6 Press the 3 or 4 key to display the desired data name.
7
Press the ENTER key. Processing appears and the
reading of data from the hard disk starts.
Writing Data
When writing to a hard disk, a name is assigned to the file auto-
matically. You can use the procedure explained later in this sec-
tion to print a list of data names for confirmation. To write data
onto a hard disk, proceed as follows.
First check that the hard disk is properly formatted. Otherwise,
the >Write Data message to be explained below will not be
shown on the message display.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Hard Disk >
appears.
Hard Disk
3 Press the 2 key.
4 Press the 3 or 4 key repeatedly until >Write Data
appears.
>Write Data
>
>
Chapter 3 Using the Operator Panel
5
Press the ENTER key. A question mark (?) appears.
>Write Data ?
6
Press the ENTER key. Processing appears, then
Waiting.
7
In this state, send the file from the computer to the
printer.
The file is written onto the hard disk given a destination
name (also referred to as a partition name) which the
printer automatically assigns one after another as
follows:
DataH001 (first data),
DataH002 (second data),
DataH003 (third data)...
In the example above, if the file TEST.TXT is the first
data to be written onto the hard disk, the destination
name will be DataH001.
As the printer receives data, the message display
changes to Processing, then when the end of the
data is received, the message display changes to
Waiting.
8
Check that the message display has changed to
Waiting, then press the GO key. This writes file to the
hard disk and instructs the printer to automatically print
out a hard disk write information page as shown below.
Partition Type:
Partition Name:
Write Partition Length: The size of the written data on
Others:
When the hard disk write information page is printed,
the message display returns to Ready.
If the writing was not completed successfully, an error
code appears on the message display. For details, see
Error Messages on page
GO key. The message display returns to Ready.
Type of data written (currently
only type 2 is supported).
The destination name of data
written to the hard disk.
the memory hard disk.
Error information.
4-6. If this happens, press the
3-32