Kyocera Mita FS-9500DN Operation Manual page 59

Chapter 3 Using the Operator Panel
NOTE
• >Cassette 3 Type or >Cassette 4 Type ap-
pears when an option paper feeder (PF-70) is in-
stalled.
• >Cassette 3 Type appears when an option paper
feeder (PF-75) is installed.
5
Press the ENTER key. A blinking question mark (?) ap-
pears.
>Cassette 1 Type
? Plain
6 Press the 3 or 4 key to display the desired cassette
type. The display changes as shown below.
Plain
Pre-printed
Bond
Recycled
Rough
Letterhead
Color
Pre-punched
Custom(1 to 8)
7
When the desired cassette type is displayed, press the
ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Selecting the Paper Source
You can select from which paper source printing will be per-
formed. If no option units are installed, the only selections are
the paper cassette and MP tray of the printer. If option paper
feeders are installed, they can also be selected.
1
Press the MENU key.
2 Press the 3 or 4 key repeatedly until Paper Han-
dling > appears.
Paper Handling >
3
Press the 2 key.
4
Press the 3 or 4 key repeatedly until >Feed Select
appears.
>Feed Select
Cassette1
3-43
5
Press the ENTER key. A blinking question mark (?) ap-
pears.
>Feed Select
? Cassette1
6
Press the 3 or 4 key to display the desired paper
source. The display changes as shown below accord-
ing to the installed option units.
(Printer's standard upper cassette when
Cassette1
option paper feeders are installed)
(Printer's standard lower paper cas-
Cassette2
sette)
(printer's MP tray)
MP tray
(Option upper paper feeder)
Cassette3
(Option lower paper feeder)
Cassette4
7
When the desired paper source displayed, press the
ENTER key.
8
Press the MENU key. The message display returns to
Ready.
Setting Duplex Printing
Using the duplex unit, you can automatically print on both sides
of the paper. The duplex unit is installed underneath the printer.
Q Q Q Q Binding Setups
The term binding refers to the manner in which printed pages of
paper are joined together (by gluing, stitching, etc.) in book
form. The two possible types of binding are long-edge binding,
in which pages are joined together along their long edge; and
short-edge binding, in which they are joined together along their
short edge. In selecting a binding type, you must also consider
the orientation of the printed page. You can use long-edge or
short-edge binding with either landscape or portrait printing.
Depending on the binding type and print orientation, the duplex
unit provides four types of binding setups. These are: (1) por-
trait, long-edge, (2) portrait, short edge, (3) landscape, long-
edge, and (4) landscape, short-edge. The figure below shows
these binding setups.
(1)
Portrait,
long-edge
(3)
Landscape,
long-edge
Binding Setups
To select duplex printing and binding setup from the operator
panel, proceed as follows.
(2)
Portrait,
short-edge
Landscape,
short-edge
(4)