Appendix D Option Units - Kyocera Mita FS-9500DN Operation Manual

Appendix D Option Units

PF-70 Paper Feeder
Holds approximately 500 sheets of A5 to A3 (11 × 17" in Ledger)
size paper. Up to two paper feeders can be attached to the bot-
tom of the printer.
PF-75 Paper Feeder
Holds approximately 3000 sheets of A4, B5 or Letter size
(8.5 × 11") paper. Only one paper feeder can be attached to the
bottom of the printer.
Network Interface Card
Is used to communicate using the network protocols such as
NetWare, TCP/IP or EtherTalk.
DF-70/DF-71 Document Finishers
Provide finishing with about 3,000 sheets a time with high-speed
and large-capacity process. DF-71 also provides punch function.
They are installed at the left side of the printer.
DF-75 Document Finisher
Provides the staple, punch (option), offset and stitch functions. It
is installed at the left side of the printer.
BC-1 Barcode Reader
Reads the barcode (ID code) printed on the paper when reprint-
ing with the code job function. It is connected to the printer with
the serial interface.
Other Options
• Hard Disk Unit
Enables the electronic sorting and job retention functions. To
be inserted into the slot OPT1/HDD designed for it on the main
circuit board of the printer.
• Memory Card (CF)
This is a microchip card that may contain option fonts, macros,
and forms. Insert the memory card into the memory card slot
located on the right of the printer. See your dealer for purchas-
ing information regarding the memory Cards that are best suit-
ed for use with this printer.
• Memory DIMM
See your dealer for purchasing information of the DIMM that
are best suited for use with this printer. See
pansion Memory for the installation procedure.
D-2
Appendix B Ex-