Kyocera Mita FS-9500DN Operation Manual page 33

Chapter 3 Using the Operator Panel
8
Press the 3 or 4 key to increase or decrease the value
at the blinking cursor. The value can be set between 0
and 50. Use the 2 and 1 keys to move the cursor
right and left.
9
When the desired maximum number of jobs is set,
press the ENTER key.
10
Press the MENU key. The display returns to Ready.
Q Q Q Q Maximum Space Assigned to Temporary Code Jobs
This changes the hard disk space that holds temporary code
jobs. You can change the maximum space from 0 to 9999
(megabytes). The actual maximum size depends on the size of
free hard disk space, however. The default size is 1/6 of the to-
tal hard disk space, rounded off in unit of 50 MB. For example, if
the total hard disk space is 3.2 GB, the default size is 500 MB.
1
Press the MENU key.
2
Press the 3 or 4 key repeatedly until e-MPS > ap-
pears.
e-MPS
3
Press the 2 key.
4
Press the 3 or 4 key repeatedly until >e-MPS Con-
figuration > appears.
>e-MPS
Configuration
5
Press the 2 key.
6 Press the 3 or 4 key repeatedly until >>Temp. Code
JOB Size appears.
>>Temp. Code JOB
Size 0500MB
7
To change the maximum disk space, press the ENTER
key. A blinking cursor (_) appears.
>>Temp. Code JOB
Size 0500MB
8
Press the 3 or 4 key to increase or decrease, respec-
tively, the value at the blinking cursor. Use the 2 and
1 keys to move the cursor right and left.
3-17
>
>
9
When the desired size is displayed, press the ENTER
key.
10
Press the MENU key. The display returns to Ready.
Q Q Q Q Maximum Space Assigned to Permanent Code Jobs
This changes the hard disk space that holds permanent code
jobs. You can change the maximum space from 0 to 9999
(megabytes). The actual maximum size depends on the size of
free hard disk space, however. The default size is 1/6 of the to-
tal hard disk space, rounded off in unit of 50 MB. For example, if
the total hard disk space is 3.2 GB, the default size is 500 MB.
1
Press the MENU key.
2
Press the 3 or 4 key and select e-MPS >.
e-MPS
3
Press the 2 key.
4
Press the 3 or 4 key repeatedly until >e-MPS Con-
figuration > appears.
>e-MPS
Configuration
5 Press the 2 key.
6 Press the 3 or 4 key and select >>Perm. Code JOB
Size.
>>Perm. Code JOB
Size 0500MB
7
Press the ENTER key, the message display shows a
blinking cursor (_).
>>Perm. Code JOB
Size 0500MB
8
Press the 3 or 4 key to increase or decrease, respec-
tively, the value at the blinking cursor. Use the 2 and 1
keys to move the cursor right and left.
9
When the desired size is displayed, press the ENTER
key.
10
Press the MENU key and the message display returns
to Ready.
>
>