Show Snmp - Edge-Core ES4612 Management Manual

4
Command Line Interface
Command Mode
Global Configuration
Example
Console(config)#snmp-server
Console(config)#

show snmp

This command can be used to check the status of SNMP communications.
Default Setting
None
Command Mode
Normal Exec, Privileged Exec
Command Usage
This command provides information on the community access strings, counter
information for SNMP input and output protocol data units, and whether or not
SNMP logging has been enabled with the snmp-server enable traps
command.
Example
Console#show snmp
SNMP traps:
Authentication: enable
Link-up-down: enable
SNMP communities:
1. private, and the privilege is read-write
2. public, and the privilege is read-only
0 SNMP packets input
0 Bad SNMP version errors
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Set-request PDUs
0 SNMP packets output
0 Too big errors
0 No such name errors
0 Bad values errors
0 General errors
0 Response PDUs
0 Trap PDUs
SNMP logging: disabled
SNMP ip filter group:
Console#
4-114