Igmp Commands (Layer 3); Ip Igmp; Table 4-73 Igmp Commands (Layer 3) - Edge-Core ES4612 Management Manual

IGMP Commands (Layer 3)

Command

ip igmp

ip igmp robustval
ip igmp query-interval
ip igmp max-resp-interval
ip igmp
last-memb-query-interval
ip igmp version
show ip igmp interface
clear ip igmp group
show ip igmp groups
ip igmp
This command enables IGMP on a VLAN interface. Use the no form of this
command to disable IGMP on the specified interface.
Syntax
[no] ip igmp
Default Setting
Disabled
Command Mode
Interface Configuration (VLAN)
Command Usage
IGMP query can be enabled globally at Layer 2 via the ip igmp snooping
command, or enabled for specific VLAN interfaces at Layer 3 via the ip igmp
command. (Layer 2 query is disabled if Layer 3 query is enabled.)
Example
Console(config)#interface vlan 1
Console(config-if)#ip igmp
Console(config-if)#end
Console#show ip igmp interface
Vlan 1 is up
IGMP is enable, version is 2
Robustness variable is 2
Query interval is 125 sec
Query Max Response Time is 10 sec, Last Member Query Interval is 1 sec
Querier is 10.1.0.253
Console#

Table 4-73 IGMP Commands (Layer 3)

Function
Enables IGMP for the specified interface
Configures the expected packet loss
Configures frequency for sending host query messages
Configures the maximum host response time
Configures frequency for sending group-specific host query
messages
Configures IGMP version used on this interface
Displays the IGMP configuration for specified interfaces
Deletes entries from the IGMP cache
Displays detailed information for IGMP groups
Multicast Filtering Commands
4
Mode Page
IC 4-229
IC 4-230
IC 4-230
IC 4-231
IC 4-232
IC 4-232
NE, PE 4-233
PE 4-234
NE, PE 4-234
4-229