Hot Standby Router Protocol Commands; Table 4-111 Hsrp Commands - Edge-Core ES4612 Management Manual

4
Command Line Interface
Defaults
None
Command Mode
Privileged Exec
Example
Console#clear vrrp 1 interface 1 counters
Console#

Hot Standby Router Protocol Commands

To configure HSRP, add the interface for each router that will participate in the virtual
router group, set the priorities, and configure an authentication string. The HSRP
protocol will automatically select the master and standby router based on the priority
settings. You can also enable the preempt feature which allows a router to take over
as the master router when it comes on line. HSRP also allows you to specify a set of
interfaces that dynamically change the router priority based on their availability.
Command
standby ip
standby priority
standby preempt
standby authentication
standby timers
standby track
show standby
show standby interface
4-320

Table 4-111 HSRP Commands

Function
Enables HSRP
Sets the priority of this router in the HSRP group
Configures the router to take over as master virtual router
for an HSRP group if it has a higher priority than the current
master virtual router
Configures a key used to authenticate HSRP packets
received from other routers
Sets the time between the master and standby router
sending hello packets, and the time before other routers
declare the active master router or standby router down
Configures an interface so that the HSRP priority changes
based on the availability of other interfaces on this router
Displays HSRP status information
Displays HSRP status information for the specified
interface
Mode Page
IC 4-321
IC 4-322
IC 4-323
IC 4-324
IC 4-325
IC 4-326
PE 4-327
PE 4-329