Table 3-3 Logging Levels; Figure 3-16 System Logs - Edge-Core ES4612 Management Manual

Level Name
debugging
informational
notifications
warnings
errors
critical
alerts
emergencies
* There are only Level 2, 5 and 6 error messages for the current firmware release.
• RAM Level – Limits log messages saved to the switch's temporary RAM memory
for all levels up to the specified level. For example, if level 7 is specified, all
messages from level 0 to level 7 will be logged to RAM. (Range: 0-7, Default: 7)
Note:
The Flash Level must be equal to or less than the RAM Level.
Web – Click System, Logs, System Logs. Specify System Log Status, set the level of
event messages to be logged, and click Apply.
CLI – Enable system logging and then specify the level of messages to be logged to
RAM and flash memory. Use the show logging command to display the current
settings.
Console(config)#logging on
Console(config)#logging history ram 0
Console(config)#
Console#show logging flash
Syslog logging: Disable
History logging in FLASH: level errors
Console#

Table 3-3 Logging Levels

Level Description
7 Debugging messages
6 Informational messages only
5 Normal but significant condition, such as cold start
4 Warning conditions (e.g., return false, unexpected return)
3 Error conditions (e.g., invalid input, default used)
2 Critical conditions (e.g., memory allocation, or free
memory error - resource exhausted)
1 Immediate action needed
0 System unusable

Figure 3-16 System Logs

Basic Configuration
4-44
4-45
4-48
3
3-29